Ballastic Black is for use on steel behind insulation, cofferdams, water tanks (non-potable), concrete and similar materials as damp-proof coating. It is also widely used below the waterline on canal boats. Bitumen products such as Ballastic Black provide an extremely flexible coating suitable for a wide range of uses both above and below the waterline. Ballastic Black is an equivalent to Intertuf 16, but has a higher percentage of volume solids. This means that when applied at the same spreading rate as competitor's products, Ballastic Black will provide a thicker coating which will give better corrosion protection and, perhaps more importantly, at a lower cost. It is a bitumen based coating that is extremely waterproof and easy to apply. It can be applied on bare steel or over existing coatings.
A two-pack solvent-free epoxy coating, a general purpose tank lining with good chemical resistance. It can be used as primer, mid or finish coat, on steel, galvanised & stainless steel, and concrete substrates.
A two-pack conductive epoxy coating, with good chemical resistance. Suitable for properly prepared carbon steel and stainless steel substrates.
Designed for drinking water tanks, Tankguard DW is a two-pack solvent-free epoxy coating. It can be used as primer and finish coat in atmospheric & immersed environments, and is suitable for properly prepared carbon steel, stainless steel, and concrete substrates.
Tankguard HB is a two-pack high-build epoxy coating with high resistance to a wide range of chemicals and solvents.
A two-pack epoxy coating, designed as a holding primer or primer in a complete tank coating system. It has excellent chemical resistance, can be used in atmospheric and immersed environments, and is suitable for properly prepared carbon steel, galvanised steel, stainless steel and concrete substrates.
A two-pack solvent-free epoxy coating, specially designed as a tank lining with very good chemical resistance.
A two-pack epoxy coating with very good chemical resistance, which can be used as primer or mid coat in atmospheric and immersed environments. Suitable for properly prepared carbon steel, galvanised steel, and stainless steel substrates.
A two-pack epoxy topcoat with very good chemical resistance, which can be used in atmospheric and immersed environments. Suitable for approved primers only, please refer to Data sheet.
A two-pack epoxy tank lining with excellent chemical resistance. It can be used as primer, mid coat or finish coat in atmospheric and immersed environments.
A two-pack moisture cured inorganic zinc ethyl silicate coating, specially designed as a tank coating and lining with excellent cargo resistance. To be used as a single coat system only, in atmospheric and immersed environments.
Follow us on:
Use the form below or send an email to info@smlpaints.co.uk
